Evolution FURY Manual de Instruções descarregar pdf (Página 22)

www.evolutionfury.com

22

FENCE ASSEMBLY (Fig. 19)

The Fence Assembly consists of two (2)

main parts:

• TheAngleGauge.

• TheRipFenceFacePlate.

NOTE: The ‘T’ slot in the Rip Fence Face

Plate is not centrally located.

• SlidetheRipFenceFacePlateontothe

two (2) mounting screws found on the

Angle Plate.

• Ensurethatthewider(20mm)portionof

the Fence Face is downwards and will lie

on the saw table when in use.

The Angle Plate can now be slid into the

Rip Fence channel found at the front of the

machine table. (Fig. 20)

Slide in from the Right Hand side ensuring

that the Locking Clamp engages correctly

with the front face of the Rip Fence channel.

FENCE ASSEMBLY AS A RIP FENCE

To use the Fence Assembly as a Rip Fence

the Face Plate must be accurately aligned

with the blade.

WARNING: Only carry out this procedure

with the machine disconnected from the

power supply.

To Align the Rip Fence:

• Ensurethatthetableisatitslowest

setting (see Fig. 23a &23b)

• SettheAngleGaugetoanindicated90

0

.

• SlidetheFenceAssemblyuptotheblade,

raising the Blade Guard by hand so that the

Face Plate rests alongside the blade and

underneath the Blade Guard. (Fig.21)

Gently tighten the Angle Gauge Locking

Clamp Screw to lock the Assembly into

the Rip Fence channel.

• CheckthattheFacePlateisinexact

alignment with the blade.

• Ifadjustmentisrequired,loosenslightly

the Angle Clamping Screw and adjust

the Angle Gauge until exact alignment is

achieved.

Fig. 21

Fig. 20

Fig. 19

height

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 31 32

Comentários a estes Manuais

Sem comentários