Evolution EVO42 Manual de Instruções

www.evolutionsteel.com42mm (1-5/8”) MAGNETIC DRILLING SYSTEMInstruction ManualRead instructions before operating this tool.EVO42Guard omitted for illu

10www.evolutionsteel.com5) PREPARATION and SETTING UP. The Electromagnet on this machine is designed to adhere to ferrous metallic surfaces only.

EVO4211www.evolutionsteel.comGETTING STARTEDUNPACKINGCaution: This packaging contains sharp objects. Take care when unpacking. This machine could requ

12www.evolutionsteel.com1234678Photograph showing machine with annular cutter fitted1. MAGNET ON/OFF SWITCH2. MOTOR ON/OFF SWITCH3. GUARD4. ANNULAR CUT

EVO4213www.evolutionsteel.com12Photograph showing machine with 3 jaw chuck & twist drill fitted1. 3 JAW CHUCK2. DRILL BITMACHINE OVERVIEW

14www.evolutionsteel.comASSEMBLY and PREPARATION WARNING: This machine must not be connected to a power source until all assembly and prep

EVO4215www.evolutionsteel.com• OperatetheRed switch (Fig. 4) situated at the rear of the machine to energise the magnet.• Checkthatthemachinei

16www.evolutionsteel.comSETTING UP WARNING: Before using the machine ensure that you have read the sections on the intended and prohibited

EVO4217www.evolutionsteel.comTo ensure Coolant/Lubrication flow: • ReleasetheCoolant/Lubricationbottlecap.Thiswillpreventavacuumbeingcreate

18www.evolutionsteel.com• Correctlypositionthemachineontheworkpiece,withtheelectromagnet energised and with the safety strap secured in pl

EVO4219www.evolutionsteel.com WARNING: Do not attempt to clean by inserting pointed objects through openings in the machines casings etc.

2www.evolutionsteel.comTABLE OF CONTENTS PAGE Introduction 03Guarantee 03Technical Specification 04Explanation of Labels and Symbols 05Intended us

20www.evolutionsteel.comSERVICED PARTS LIST

EVO4221www.evolutionsteel.comSERVICED PARTS LIST

22www.evolutionsteel.comDECLARATION OF CONFORMITYEC DECLARATION OF CONFORMITYIn accordance with EN ISO 17050-1:2004The manufacturer of the product cov

EVO4223www.evolutionsteel.comNotes:

EVO423www.evolutionsteel.comIMPORTANT INFORMATIONPlease read these operating and safety instructions carefully and completely. For your own safety, if

4www.evolutionsteel.comTECHNICAL SPECIFICATION Max Machine Height (mm): 670 (26-1/4”)Min Machine Height (mm): 360 (14-1/8”)Machine Width (mm): 180 (7”

EVO425www.evolutionsteel.comSAFETY LABELS & SYMBOLS WARNING: Do not operate machine if warning and/or instruction labels are missing ordamag

6www.evolutionsteel.comELECTRICAL SAFETY - EU ONLY! WARNING: Operating on a lower than rated voltage will result in the electro magnet bei

EVO427www.evolutionsteel.comPOWER TOOL GENERAL SAFETY INSTRUCTIONS WARNING: Read all safety warnings and instructions. Failure to follow th

8www.evolutionsteel.comthat cannot be controlled with the switch is dangerous and must be repaired.c) Disconnect the power tool from the power source

EVO429www.evolutionsteel.com• NevercarrytheMagneticDrillbythepowercord.CarryingtheMagneticDrillbythepowercord could cause damage to t